NARGESA C2006, Manual, Page: 13 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 12
4. INSTALLMENT AND START UP
4.1. Location of the machine
The machine will be placed properly so that it doesn’t have to be moved, in case this was not possible then
it is necessary to follow the rules described in the Transport section. It muts be placed on a flat and levelled
surface to avoid vibrations and any sort of movement while it’s performing. It is possible to level the
machine by using the screws at the bottom of the machine, at each corner.
Picture 5. Anchor points of the machine
4.2. Dimensions and working site
The dimensions of the machine are to be considered when the machine is put down, as well as the
operative working zone and the possible different sizes of the part to be worked.
The machine will be only used by one operative, who will be located at the front side of the machine and
never in a lateral of it since he has to keep control over the whole set of the machine, moreover the main
prtection devices are designed for th efrontal use of it.
Picture 6. Working site