NARGESA C2006, Manual, Page: 19 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 18
The continuous operational mode works in the following way:
The pedal can be pressed and released in this operational mode. Once the pedal is pressed, the blade
moves to the lower vertical position, cutting the sheet. It is then raised automatically until it reaches the
upper rest position. The blade will stay in this position until the pedal is pressed again. If various cuts need
to be made at the same position, simply press the pedal and keep it pressed as long as required. In this
case, the cuts will be made sequentially, and the operator simply enters the sheets to be cut into the
machine.
The cut counter will increase by one each time the pedal is pressed, or each time the shear blade makes a
cut and returns to the upper position if operating in continuous mode.
5.5. Gauge retraction
The gauge retraction is mainly used to prevent the sheets from being damaged when they are cut. This
function can be activated by pressing . The image will change to white, indicating that the function
has been enabled. The function is disabled by pressing (X) again, and the image will go back to being
transparent.
Once activated, the machine will behave as follows:
After entering all the cut data and activating this function.
The gauge retraction can be enabled in both single and continuous mode.