NARGESA C2006, Manual, Page: 23 / 71

C2006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 22
Once we are satisfied with the program created, it needs to be saved. To do so, press and the on-
screen keyboard appears, as shown below
Enter the program number and press the button to confirm.
We can now operate in automatic mode with the program created beforehand. The hydraulic pump needs
to be activated in order to do so, by pressing the button. Then start the cycle by placing the gauge at
the cut dimension defined for the current step. This is done by pressing the button. When the gauge
is in position, press the cutting pedal as instructed on screen. The machine will start to do the first 500 mm
cut as specified in step 1. Then it will move on to step 2. After pressing down the pedal it will make the
specified cuts and continue the sequence up to the end of the program. A message will then appear on the
screen noting that the part has been finished.
5.10. Program management
Numerical control of the shears allows multiple programs to be defined which can be used in automatic
mode. These programs are saved in the memory and can be loaded, changed and deleted when required.