NARDA PMM ER9000, User Manual

Page: 68 / 106

7-2 Remote control
7.5 List of
commands
Query COMMANDs
Syntax Function
?3PR* Tells whether the apparatus is in Conducted or Radiated range
?AAT*
Requests the Attenuator status for Analyzer mode.
?ACE*
Requests the Center frequency for analyzer mode
?ADT*
Requests the detector used for Analyzer mode
?AHT* Requests the Hold Time for Analyzer mode.
?AOP* Requests the Stop frequency for analyzer mode
?ART* Requests the Start frequency for analyzer mode
?ASP*
Requests the Span frequency for analyzer mode
?BAT
Requests the Battery voltage
?BWL
Requests the RBW filter list
?CFA* Sends back the ID of the conversion factor
?CRA* Tells whether RMS-AVG detector is available
?DET*
Reports the five detector for manual mode
?DMD*
Requests the status of demodulator.
?DMV*
Requests the volume of demodulator.
?FPGA Sends back a string containing information about version of FPGA.
?HIS Requests the High sensitivity mode status
?IDN* Requests model, release and date of firmware
?MAA
Requests maximum available attenuation
?MAF*
Requests the tuning frequency for manual mode
?MAT*
Requests the Attenuator status for Manual mode
?MFS Requests minimum available frequency
?MHT*
?MPA*
?MPS* Requests the Hold Time for manual mode
Requests the Preamplifier status for Manual mode
Requests the Preselector status for Manual mode
?PAM
Requests the mode of the Preamplifier for the Conducted range
?RBW Sends back a string expressing the selected RBW
?RFS Request the status of the RF Module for Radiated range
?S/N* Requests Serial Number internally stored by manufacturer
?TAT*
Requests the MinAtt value
?TGF
Requests the tuning frequency of the internal CW signal generator
?TGL
Requests the output level of internal CW signal generator
?TGS Requests the status of the internal signal generator
?TGT Requests the tracking mode of the internal CW signal generator
?TMP Sends back a string showing the temperature expressed in Celsius (°C)
?UHT*
Requests the actual Hold Time currently or lastly used
?UPP*
Requests the status of input PINs of the User Port