Napoleon Condo Pack, Installation And Operating Instructions Manual

Page: 29 / 128

29
IOM
W415-2288 / 08.29.2019
Small
Medium
Large
Position the cover reducing plate
over the electrical slot and secure
the plate to the cabinet using ALL
three screws provided.
1. Attach the cable to a strain relief connector. The strain relief connector must be certified and approved for
the required gauge per standard local and national electrical codes.
2. Insert the threaded end of the strain relief
into the electrical opening and pass the
supply cable through.
3. From the opposite end attach the
strain relief locknut onto the cable.
Based on cable gauge, determine the
reducer plate with right diameter size.
Reducing Cover Plates:
Lock Nut
Strain relief Lock Nut
Power Supply Cable
Reducing Cover Plate
Reducing Cover Plate
Electrical Slot
Connect power cables to
L1/L2 Distribution blocks.
Connect main grounding cable to
ground lug.
Power
cables
L1
L2
REPLACE BACK ALL ACCESS PANELS
BEFORE OPERATING. FAILURE TO DO SO
CAN RESULT IN ELECTRICAL SHOCK
CAUSING SEVERE INJURIES OR DEATH.
IT IS THE ELECTRICIAN’S
RESPONSIBILITY TO ENSURE THAT
THE WIRING AND CONNECTIONS
ARE COMPLIANT TO THE LATEST
EDITIONS OF THE CANADIAN
ELECTRICAL CODE
AND NATIONAL AND LOCAL CODES.
THESE INSTRUCTIONS ARE
INTENDED TO BE USED BY QUALIFIED
PERSONNEL ONLY, TRAINED IN
INSTALLING THIS TYPE OF UNITS.
RISK OF ELECTRICAL SHOCK !
DISCONNECT POWER BEFORE
INSTALLATION.
HEATING
MODULE
FRONT PANEL
COOLING
SECTION
SUPPLY
OUTLET
ELECTRICAL
SUPPLY SLOT
SIDE
ACCESS
PANEL
Locate the
electrical supply slot
on the top of cabinet enclosure.
Remove the access panels.
Secure the strain
relief by tightening
the lock nut. The lock
nut should be tightened
with a tool (such as a pair of
pliers) to ensure the strain relief is
properly grounded to the fixture.
Ground lug
Ground wire
Strain relief
Power Supply Cable
Power Cables
Install power supply cable:
4
6
5
7
1 3 2
WARNING
! !
5.1.3 Power Supply Installation