L
NAPCO Security Systems
X
GEM-P1632 Programming Instructions
!
Page 41
CLEAR PROGRAM OPTIONS (ADDRESS 1197 & 1198)
Clear Dealer Program (Erases Dealer Program)
This
erases the dealer program
. Use this feature to start a
customized default program. Program Data and System
Status Memory is erased where Scheduled Data and Zone
Descriptions are maintained.
Access address 1197, then press the
U
button. Data entry is not allowed.
NOTE:
Enter Easy Menu Driven Program Mode to program system again.
GEM-RP1CAe2 Keypad
1197 XX
GEM-RP2ASe2 Keypad
1197 XX
Cold Start (Erases Entire Program)
This erases the entire program including Dealer Program
by erasing Program Data, Zone Description Data and
System Status Data (similar to a new panel).
Access address 1198, then press the
U
button. Data entry is not allowed.
NOTE:
Some features (schedules) can only be programmed again with the
Downloading Software.
GEM-RP1CAe2 Keypad
1198 XX
GEM-RP2ASe2 Keypad
1198 XX
Clear Program Options
& User Program Mode
USER PROGRAM MODE
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-up.
!
After entering codes or data, press the save
U
button.
Data will not be stored into memory unless this button is pressed.
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
!
Press the
C
button to silence the sounder and exit the User Program Mode.
If a GEM-RP2ASe2 or GEM-K2AS keypad is used, configure address jumpers as Keypad #1 (see the section of this manual
Configuring the GEM-RP2ASe2/GEM-K2AS Keypad). Use the
R
or
A
button to manually scroll the display at the end of
each programming line.
NOTE:
For ease of programming, it is recommended that a GEM-RP1CAe2 or GEM-K1CA be used as Keypad #1.
(A new GEM-
RP1CAe2/GEM-K1CA is automatically configured as Keypad #1). See Keypad Configuration Mode and WI897 for more information.
ACCESSING USER PROGRAM MODE
1. Press
EEEEEE
R
2. Press
Q
Until
“
TURNON PROG Y/N
”
(GEM-RP2ASe2/GEM-K2AS) or
“
17
”
(GEM-RP3DGTL/GEM-K3DGTL or
GEM-RP4RFC/GEM-K4RF) appears on the LCD screen.
3. Press
P
To Enter User Program Mode.
4. Press
C
To Exit User Program Mode when finished.
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
