© by N&W GLOBAL VENDING S.p.A.
33
11 2008 3275 00
STATiSTiCS
the operation data of the machine are stored in general
and relative counters that can be reset without losing
total data.
statIstIcs
electronIc coUnter
eVaDts
DIsplaY statIstIcs
Delete statIstIcs
DIsplaY relatIVe stat.
Delete relatIVe stat.
prInt statIstIcs
prInt relatIVe stat.
tecH> x.x
E
lEctroNic
couNtEr
t
o
Display
tHE
ElEctroNic
couNtEr
an electronic counter is intended to store all the dispens-
ing cycles you have performed since you last reset it in
an aggregated manner.
t
o
rEsEt
tHE
ElEctroNic
couNtEr
You can reset the electronic counter.
t
o
ENablE
tHE
ElEctroNic
couNtEr
at
tHE
start
-
up
Function used to enable or disable the display of the
total number of dispensing cycles that have been sold
since you last reset, while you are powering on the ma-
chine.
Eva-Dts
two codes are used to identify the machine and recog-
nise the data transfer terminal according to the eVaDts
(European Vending Association Data Transfer System)
communication protocol:
c
ommuNicatioN
protocol
Use this function to decide the communication protocol
to be used for the communication of the device intended
to acquire data.
the communication protocols made available are listed
here below.
DDcmp
the following parameters can be configured:
Pass code
-
: It is a 4-digit alphanumeric code (0-9; A-F)
that must be the same as the one of the data transfer
terminal for identification purposes.
setup by default 0000
Security code
-
: It is an alphanumeric code for mutual
recognition between the machine and the eVaDts
terminal.
setup by default 0000
End of transmission
-
:
DEx
/
ucs
no parameter can be configured for this protocol.
D
ata
traNsmissioN
to select which communication interface to use for data
transfer. the interfaces made available are listed here
below:
"rs232" and "IrDa": to dialogue with data acquisition
-
devices
"alWaYs eVaDts" to dialogue with data acquisition
-
and transmission devices (telemetry)
t
raNsmissioN
spEED
(
bauDratE
)
to choose the communication speed of transmission.
setup by default 2400bps
c
oNNEctioN
If you activate this function, the machine will be waiting
for connection with a device in order to acquire eVaDts
data.
D
isplay
gENEral
statistics
press the enter key
�
to display the data you have
stored in sequence, i.e.:
1 - counter by single selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
r
EsEt
gENEral
statistics
Statistics can be reset either globally (all types of data)
or selectively, i.e. by:
selections
-
discounts-overprices
-
failures
-
coin mechanism data
-
press the enter key
�
to display the request for confir
-
mation “Do you confirm?”
�
flashing on and off.
press the enter key to display the “execution” message
for some seconds and to reset statistics.
