© by N&W GLOBAL VENDING S.p.A.
32
11 2008 3275 00
the following items are provided for:
Bank setup
-
combined selection setup. they are the result of a
-
combination between a cold product (dispensed by
the same machine) and a hot product (dispensed by a
machine of the H&c range (if necessary, mounted in a
bank)
“slavepriceHolding” parameter setup
-
“NewZeta” setup (NewZeta or NewZeta2) in case of a
-
bank with two Diesis dispensing machines of the same
kind
transmission of the “resetslave” can message in
-
case of a bank with a slave dispensing machine
“Monitor” mode start in case of a bank with a slave
-
dispensing machine
If an executive payment system is set to the "price hold-
ing" mode on the master, the information shall be also
set up on the slave machine software.
the payment system of the slave machine shall always
be defined as a "validator".
In case of power failure, both machines will display the
"communication failure" message.
m
acHiNE
sErial
NumbEr
after having displayed the "Machine code" function,
you can change the 8-digit numeric code identifying the
machine (0 by default).
o
pErator
coDE
after having displayed the "Manager code" function, you
can change the 6-digit numeric code identifying groups
of machines (0 by default).
s
itE
coDE
Use this function to store a code associated with the
installation site of the machine.
i
NstallatioN
DatE
Use this function to store the installation date of the
machine.
TEST
this group of functions is intended to test some users
and devices of the machine.
test
Motor test
aUtotest
tecH> x.x
m
otor
tEst
It is intended to operate all the motors of selections in a
sequence and to display the selection in question.
a
utotEst
a function is implemented in the software to check the
correct operation of the machine devices half-automati-
cally.
some tests occur automatically whereas others require
the manual operation of the component under test.
press button
�
to test the next device.
the devices under test are listed here below:
Keyboard
-
: press the key required by the display; if it
can operate properly, you will be required to press the
next key.
Temperature:
-
to display the temperature value meas-
ured by the probe.
In case of power failure, -11.0 will appear. In case of a
short-circuit, 41.0 will appear.
Buzzer:
-
a series of sounds is produced.
Compressor:
-
press key
�
and
�
to activate and
deactivate the compressor.
Selections:
-
to activate all selections in a sequence.
Coin mechanisms:
-
to make sure that the communica-
tion with the coin mechanism is properly working and to
check which validator lines are set up as active.
Neon:
-
to check the operation of the lamps of aesthetic
panels
