N&W Global Vending Colibri UL 120V, Use And Installation Manual

Page: 17 / 52

13
© by N&W GLOBAL VENDING SpA 02-2007 266 00
INSTALLING THE PAYMENT SYSTEM
The machine is sold without payment system, there-
fore the installer of such a system has sole responsi-
bility for any damage to the machine or to things and
persons caused by incorrect installation.
The machine is electrically pre-set for the installation of
MDB payment systems, and namely:
- coin accepter or “validator”
- change-giver coin mechanisms or “changer”
- bill accepter or “bill validator”
- key / magnetic card reader or “cashless”
that can be used in various combinations.
Compatibility for housing the payment systems must
be ascertained by and under the sole responsibility of
the installer.
When switched on, the machine goes through a control
routine to determine which payment systems are actually
installed and therefore configure the correct system.
Install the validator and make sure that the programming
of the relevant parameters is correct.
Other payments systems such as “change giver” and
“cashless” can be installed by using the specific kits.
The “cashless” systems can be housed inside the ma-
chine; other payments systems such as “change giver”
must be housed inside the base cabinet.
FILLING THE WATER SYSTEM
When the machine is switched on the conditions of the
following are checked: air-break (full or empty), pump
priming and boiler.
When pressing twice the programming button located on
the inside of the vending machine door, the machine goes
into Programming mode.
Press in a sequence buttons 3 and 6 to perform the
installation routine; the installation routine consists of:
- Opening the water mains solenoid valve and filling the
air-break.
- Opening the solenoid valve so that the air may be bled
from the boiler and 400 cc of water filled.
- The message “Installation” will be shown on the LCD
display for the entire duration of the cycle.
N.B.:
If there is no water flow from the mains during the
installation cycle, the machine will stop until water is
resumed or the machine is switched off.
Important notice!!!
If a considerable amount of air bubbles is formed in the
water system, for example during maintenance, it is pos-
sible that an installation cycle is automatically started
when the machine is switched on.
WATER SOFTENER UNIT
The machine is sold without water softener.
Should the water be very hard, a water softener unit
(optional) can be installed.
The water softener, available as accessory, must be
replaced or regenerated regularly following the directions
from the manufacturer.