N&W Global Vending Colibri UL 120V, Use And Installation Manual

Page: 24 / 52

20
© by N&W GLOBAL VENDING SpA 02-2007 266 00
PROGRAMMING MENU
When the programming button located on the internal side
of the push-button board (see Fig. 30) is pressed twice the
machine will be set to “Programming” mode.
The message “Programming” is shown on the display for
approx. 2 seconds and then the first option of the Program-
ming menu is presented.
When in Programming mode the buttons take on the
following functions:
“Machine config.” Setting the machine configura
tion
“Selec. counter” Setting the number of selections
after which the machine will lock
“Prom. message” Enabling and setting the
promotional message
“Language” Setting the language used to
display the messages
“Whipping time” Setting whipping time for instant
coffee
“Prog. password” Enabling the password to access
programming
“Selec. configuration” Determining the accessories to
be dispensed with each single
button (automatic models only)
“Special sales” Setting free vend and
jug facilities parameters
“Set date/time” Setting the system date/time
“Set wash” Setting the time for mixer
washing
“Discount time band” Setting a time band with
differential price selections
“Consecutive sel.” setting the number of selections
after which the machine will
pause for heating
“Pre-grinding” Setting the option of pre-grinding
“Set Temperature” Setting the boiler temperature
“Display pre-sel.” Setting the pre-selection on the
display (semiautomatic models
only)
“Syrup pre-sel.” Setting the syrup pre-selection
on the display (semiautomatic
models only)
“Syrup overprice” Setting an overprice if selections
with syrup are made
“Syrup cycle” Dispensing syrup before or after
the selection
“Dex UCS-EVADTS” Acquiring the EVADTS statistics
1 - Previous function / Decrease data item (-1)
2 - Exit function / Cancel change
3 - Machine manual installation
4 - //
5 -
Next function / Increase data item (+1)
6 - Confirm function / confirm data
7 - Change data item
8 - Reset failures
Buttons “1”, “2”, “5”, “6”, “7” are used for scrolling through
the menu or changing data.
Buttons “3” and “8” are for direct functions: press button “3”
for filling the hydraulic system, even with the air break full.
Press button “8” for resetting the present failures.
Scroll through the menu with the “ ”and “ ” buttons to
show the following functions:
“Curr. failures” Reading current failures
“Water dose” Setting the water doses
“Powder dose” Setting the powder doses
“Set Prices” Setting the prices
“Set Prices/button” Prices/button combination
enables/disables button
“Basic coin / DP” Setting the basic coin value and
decimal point position
“Payment systems” Validator
MDB
“Initialise” Initialising the RAM
“Machine code” Setting the machine identifica
tion code
Fig. 24