N&W Global Vending Colibri UL 120V, Use And Installation Manual

Page: 28 / 52

24
© by N&W GLOBAL VENDING SpA 02-2007 266 00
MACHINE CONFIGURATION
When the “Machine Config.” function is displayed, the
machine configuration can be changed, and namely:
- cup dispensing / without cup (for automatic models)
- water supply from the mains or from the tank
- presence of the equipped base cabinet
- fast cycles ON / OFF
- coffee grounds tray ON / OFF
Press the confirm button “ ” to display the current status;
when pressing the change button “ ” the data item starts
blinking and can be changed with the “ ” and “ ” buttons.
IMPORTANT NOTICE!!!
When initialising the machine, the configuration takes
on the default values.
THEREFORE, AFTER INITIALISING THE MACHINE
MUST BE RECONFIGURED.
When the “fast cycles” function is enabled, some of the
time that is useful for improving the drink quality is elimi-
nated.
Instant selections
- All of the products that compose the drink are dis-
pensed at the same time.
- the “post-whipping” time is eliminated.
Espresso selections
- Pre-brewing of ground coffee is not performed.
- the pump, used to increase the boiler pressure after an
instant drink selection, is not started;
- the “post-whipping” time is eliminated.
SELECTION COUNTER
This function is used to lock the machine after a program-
mable number of coffee selections, and a programmable
number of instant selections; alternatively, the machine
can be locked after a programmable number of selections.
Since this is a control tool used only by the vending
operator, a 4-digit password must be entered.
After entering the password, it is possible to set the number
of selections after which the machine locks, read the
number of selections already made and reset the lock
counter.
N.B.: The counters are set to zero by default.
With the counters set to zero, this function is disabled.
SETTING THE PROMOTIONAL MESSAGE
When this menu is displayed, press the confirm button “ ”
to display whether or not the message is enabled (disabled
by default).
If the message is enabled, when pressing the confirm
button “ ” the first character will start blinking and can be
changed.
The buttons will take on the following functions:
1 - Go to the next character
2 - Go to the previous character
3 - Upper case/lower case
The values are displayed alternately by pressing the
button sequentially.
The message is stored by pressing button “2” when on the
last position.
LANGUAGE SELECTION
This function is used to select the language to be used for
displaying the messages.
WHIPPING TIME
This function is used to define how long (in tenths of a
second) instant coffee is to be whipped according to the
amount of drink to be obtained.
PROGRAMMING ACCESS PASSWORD
This function is used to enable the request for a password
to access the programming procedures.
The password is the button sequence 1 1 2 2 and cannot
be changed.
SELECTION CONFIGURATION
(for automatic models only)
This function is used to determine, as an exception to the
machine configuration, which accessories should or should
not be dispensed for a specific selection.
The following is possible for each selection button (1 to 8,
excluding the pre-selection buttons):
- not dispense the cup (if the machine configuration
includes the cup, but not vice versa);
- not dispense the stirrer if the selection is unsweet-
ened;
- not dispense sugar and stirrer for selections which are
defined as sweetened (but not dispense sugar for
selections which are defined as unsweetened).
The settings defined with the selection configuration are
used also for complete test selections.
Fig. 25