2932
Figure. 6.5.7. - 67. Feeding quantity control lever
If the seed and fertiliser drill is equipped with a gearbox, the rough adjustment of the
feeding quantity is carried out by adjusting the roller width and the ne adjustment is
carried out from the machine transmission by adjusting the gearbox control lever (1).
The feeding quantity increases when the value of the adjustment scale increases and
vice versa.
Adjust the width of the feeder roller in accordance with section 6.5.5. ADJUSTING THE
WIDTH OF THE FEEDER ROLLER. When seeding grain and fertiliser, the rollers should be
in position 10. When seeding small seeds, the rollers should be in position 2.
6.5.8. Adjusting the bottom flap position
Figure. 6.5.8. - 68. Adjusting the bottom ap position
1. Change the position of the control lever (1) in the front of the seed and fertiliser drill on
the notch scale based on the material to be seeded.
Figure. 6.5.8. - 69. Bottom ap positions
When seeding small seeds, the bottom ap should be in position 0.
When seeding grain and fertiliser, the bottom ap should be in position 1.
When seeding large seeds, such as peas or beans, the bottom ap should be in
position 3.
When seeding organic fertilisers, the bottom ap should be in position 3.
2. Change the position of the control lever in the rear of the seed and fertiliser drill
accordingly.
Operation and maintenance
manual
1.00
Cerex 300
70 (156)
Summary of Contents for Cerex 300 SeedPilot
Page 159: ...Hydraulic schematic Appen dix 2 Cerex 300 1 Appendix 2 Hydraulic schematic...
Page 160: ...Hydraulic schematic Appen dix 2 Cerex 300 2...
Page 161: ...Electrical Diagram Annex 3 Cerex 300 1 Annex 3 Electrical Diagram...
Page 162: ...Electrical Diagram Annex 3 Cerex 300 2...
