2912
1. Connect the cable (1) of the RDS controller display to the cable (2) connected to the seed
and fertiliser drill.
Fasten the cable properly so that it is not pinched during turns or lifting.
Figure. 5.2.2. - 41. Fastening the RDS controller display
2. Fasten the display bracket (3) to the plate (5) by using a screw (6).
3. Fasten the display bracket (4) to the cabin with two fastening screws (4).
Attach the display in a location where view is not obstructed but where the
display is easily viewable by turning one's glance while driving. Fasten the display
at a suitable height so that the buttons can be reached effortlessly.
4. Fasten the controller display (1) to the display bracket (3) by using a screw (2).
5.3. Connecting to tractor
DANGER
Crushing hazard when connecting or disconnecting the seed and fertiliser drill. Safety
distance 5 m. Be extremely careful if someone else is near the seed and fertiliser drill
and tractor giving instructions on connecting and disconnecting.
Wear protective gloves when connecting the seed and fertiliser drill to the tractor.
1. If the machine is equipped with a wheel packer, adjust the length of the wheel packer
draw boom in accordance with section 5.3.1. ADJUSTING THE WHEEL PACKER BOOM
2. Connect the drawbar of the seed and fertiliser drill to the tractor’s hitch or the wheel
packer draw boom to the tractor’s link arms.
3. Raise the machine by using the tractor hydraulics.
4. Raise the ground support to the top position in accordance with section 5.3.2. USING THE
Operation and maintenance
manual
1.00
Cerex 300
50 (156)
Summary of Contents for Cerex 300 SeedPilot
Page 159: ...Hydraulic schematic Appen dix 2 Cerex 300 1 Appendix 2 Hydraulic schematic...
Page 160: ...Hydraulic schematic Appen dix 2 Cerex 300 2...
Page 161: ...Electrical Diagram Annex 3 Cerex 300 1 Annex 3 Electrical Diagram...
Page 162: ...Electrical Diagram Annex 3 Cerex 300 2...
