DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 6
3. Cut the two wires extending from the side marker light
bulb socket as shown in Figure 9. Set the light bulb
socket assembly aside for later.
Figure 9. Side Marker Light Disconnection
4. Strip the insulation back 1/4-inch (6 mm) from the end
of the remaining wires to expose the conductors. See
Figure 9.
STRIP
INSULATION 1/4"
CUT TWO
WIRES HERE
SIDE MARKER
LIGHT BULB
SOCKET
6"
5. The wiring extension harness (P/N 59291) contains
a red wire and a green wire. There are butt splice
connectors crimped onto each end of both wires. See
Figure 10.
Figure 10. Wiring Extension Harness
6. Insert the end of one of the stripped wires into one
of the extension harness butt splice connectors
(Figure 11) and crimp.
Figure 11. Wire Splicing
7. Insert the end of the other stripped wire into the
remaining butt splice connector on the same end of
the extension harness (P/N 59291) and crimp. See
Figure 11.
8. Push the spliced wiring extension harness (P/N 59291)
inside the cabinet through the side marker hole.
9. If installing the dual hose reel kit (P/N MQPDUALREEL50),
repeat steps #2–8 on the battery side of the air
compressor.
DO NOT remove the battery-side
tail light!
The battery-side electrical wiring can be
accessed by opening the cabinet door.
EXTENSION
HARNESS
P/N 59291
RED WIRE
GREEN WIRE
BUTT SPLICE
CONNECTOR
BUTT SPLICE
CONNECTORS
STRIPPED
WIRES
EXTENSION
HARNESS
P/N 59291