DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 10
2. From inside the frame, insert the spliced wiring
extension harness (P/N 59291) through the newly
drilled 3/4-inch hole in the frame so that it extends out
of the pivot base plate hole as shown in Figure 21.
Figure 21. Side Marker Wiring Connection
3. Insert the stripped end of one of the side marker wires
into one of the extension harness butt splice connectors
(Figure 21) and crimp.
4. Insert the stripped end of the remaining side marker
wire into the remaining extension harness butt splice
connector (Figure 21) and crimp.
5. Place the side marker light bulb socket into the
hole in the pivot base plate (P/N 59234). Secure
the side marker lens and foam backing to the
pivot base plate with two M4-0.7 × 12 mm screws
(P/N 28922-083) and two M4 hex nuts (P/N 32664)
See Figure 22.
EXTENSION
HARNESS
P/N 59291
PIVOT BASE
PLATE
BUTT SPLICE
CONNECTORS
SIDE MARKER
LIGHT
Figure 22. Side Marker Installation
6. Reinstall the tail light and rubber seal on the fuel tank
side of the air compressor.
7. If installing the dual hose reel kit (P/N MQPDUALREEL50),
repeat steps #1–5 on the battery side of the air
compressor.
HOSE REEL INSTALLATION
1. Insert the right reel mount (P/N 59275) into the pivot
base (P/N 59272) as shown in Figure 23.
Figure 23. Reel Mount Installation
SIDE MARKER
LIGHT BULB
SIDE MARKER
LENS
M4 HEX NUT
P/N 32664
FOAM
BACKING
PIVOT BASE
PLATE
P/N 59234
M4-0.7 × 12 mm
SCREW
P/N 28922-083
RIGHT REEL
MOUNT
P/N 59275
PIVOT BASE
P/N 59272
