DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 5
3. Secure the new bumper (P/N 59269) to the chassis
with the four 1/2-13 × 1-1/2" hex head bolts (P/N 5218),
flat washers (P/N 0447), and 1/2"-13 flange nuts
(P/N 26328). See Figure 6.
Figure 6. Bumper Installation
WIRING EXTENSION INSTALLATION
To install the wiring for this kit, the tail light
on the fuel tank
side
of the air compressor must be removed.
1. Remove by hand the rubber seal securing the tail light
(Figure 7)
on the fuel tank side
of the air compressor.
Disconnect the tail light and set it and the rubber seal
aside.
Figure 7. Tail Light Removal
BUMPER
P/N 59269
FLAT WASHER
P/N 0447
1/2"-13
FLANGE NUT
P/N 26328
1/2-13 × 1-1/2"
HEX HEAD BOLT
P/N 5218
RUBBER
SEAL
TAIL LIGHT
2.
On the fuel tank side
of the air compressor, remove
the two bolts securing the rear side marker lens
(Figure 8) to the frame. Set the lens and foam backing
aside and discard the bolts.
Figure 8. Side Marker Lens Removal
SIDE MARKER
LENS
REMOVE
TWO BOLTS