DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 4
DRAINING THE FUEL TANK
If there is fuel in the fuel tank, it must be drained before
performing this installation.
1. Prepare a container (Figure 3) into which to drain the
fuel.
Figure 3. Draining the Fuel Tank
2. The fuel drain bolt (Figure 3) is located on the fuel
tank side of the air compressor at the rear of the trailer
frame. Loosen the bolt to allow any fuel inside the tank
to drain into the container. Retighten the fuel drain bolt
when finished.
NEW BUMPER INSTALLATION
1. The fuel tank base cover (Figure 4) must be loosened
to allow access to the bumper hardware. Loosen the
seven hex head bolts securing the fuel tank base
cover to the frame.
DO NOT
remove the bolts nor the
cover itself.
FUEL TANK
DRAIN BOLT
CONTAINER
Figure 4. Fuel Tank Base Cover
2. Remove and discard the two hex head bolts securing
the existing rear bumper (Figure 5) to the chassis.
Discard the rear bumper.
Figure 5. Rear Bumper Removal
FUEL TANK
BASE COVER
FUEL
TANK
LOOSEN
BOLTS
HEX HEAD BOLT
REAR
BUMPER