DIS185SSI4F AIR COMPRESSOR — HOSE REEL INSTALLATION INSTRUCTIONS P/N EE60468 — REV. #0 (04/16/18) — PAGE 15
BALLAST INSTALLATION
1. To open the storage compartment at the front of the
air compressor, turn the storage compartment door
thumb screws counterclockwise and open the door
(Figure 35).
Figure 35. Tool Tray Removal
2. Remove the four bolts, lock washers, and flat washers
securing the tool tray inside the storage compartment
(Figure 35). Set the tool tray and washers aside, and
discard the bolts.
3. I f i n s t a l l i n g t h e s i n g l e h o s e r e e l k i t
(P/N MQPSINGLEREEL50), place
two
ballast plates
(P/N 59290) inside the storage compartment as
shown in Figure 36. If installing the dual hose reel kit
(P/N MQPDUALREEL50), place
three
ballast plates
inside the storage compartment.
STORAGE
COMPARTMENT
DOOR
THUMB
SCREWS (2)
DISCARD
BOLTS
RETAIN
WASHERS
TOOL TRAY
Figure 36. Ballast Plate Installation
4. Place the tool tray on top of the ballast plates
(P/N 59290), and secure the tray and plates to the
inside of the storage compartment with the four
M8 × 40 mm bolts (P/N 42346) and the four lock
washers and flat washers that were removed earlier.
See Figure 36.
POST INSTALLATION
1. Tighten the seven hex head bolts securing the fuel tank
base cover to the frame.
2. Make sure all fasteners are tightened securely.
3. Reconnect the negative cable (
BLACK
) to the negative
(
−
) terminal on the battery.
4. Refill the fuel tank with diesel fuel.
BALLAST
PLATE
P/N 59290
M8 × 40 mm
BOLT
P/N 42346
TOOL TRAY
EXISTING
LOCK
WASHER
EXISTING
FLAT
WASHER