Multi-Tech MultiModem ISDN MT128ISA-UV, User Manual

Page: 57 / 85

58
MultiModemISDN User Guide
MT128ISA/PCI
5. If you would like to activate BOD (Bandwidth on Demand), check Enable BOD.
The default value for Data Flow Rate is 1Kbytes/sec. The Inactivity Timeout defaults to 5
minutes. This setting is used to establish a second channel when the data flow rate in the
first channel is over the set value. At a default value of 1Kbyte/second, the second channel
is dropped if data flow is lower than 1 Kbyte/second averaged over 5 minutes or if an
incoming or outgoing voice call is initiated.
6. To set up Multilinking, click on Add. Select the Additional Link and click OK The
additional link will display on the screen.
Figure 2-52. Configuring Multilinking
7. Highlight the new link and click Edit. Enter the remote telephone number in the Call out
number field. If your telephone company provides a Call out subaddress, enter it here.
Click OK on each screen to exit channel configuration.
Windows 2000 POTS/Voice Port Configuration
The POTS/Voice feature is available only on models MT128ISA-UV and MT128PCI-SV.
1. On the ISDNLink Configuration screen (figure 2-48), highlight the POTS/Voice port and
click Properties. The screen shown in figure 2-53 displays.
Figure 2-53. ISDN POTS Settings
2. Select the appropriate Codec, Call Type and Dial Standby options for your POTs device.
(Refer to Chapter 2 “Before You Begin” for addition information about options available on
this screen).
3. When you have completed the POTS port configuratio, click OK.
Now you are ready to set up the POTS/Voice port.
1. Return to the ISDNLink Configuration screen (figure 2-48 and expand the POTS device
section.