Installing the transport locking
device on driving end (KS)
Note:
Install plate (6) on the upper part of the openings only.
1.
Secure the plates (6) with screws (4) and washers (5) at the lateral openings on both sides of the flywheel
housing and tighten to the specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M16
Tightening torque
250 nm +25 nm
2.
Screw locknut (2) onto screws (1) up to the end of the thread.
3.
The long side of holder (3) must point downwards. Insert holder (3) through the openings of plate (6).
Note:
Holder (3) must lock only the flywheel, not the ring gear.
4.
Screw in screw (1) in bores of holder (3) until holder (3) is locked in position.
Note:
Screw (1) must be tightened stepwise and alternately on both sides of the flywheel housing.
5.
Tighten screw (1) to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M10
Tightening torque
30 Nm +3 Nm
6.
Install locknut (2) of screw (1) on plate (6) and tighten.
Removing the transport locking
device from driving end (KS)
1.
Release the locknuts (2) on both sides of the
flywheel housing, remove screw (1) and take
off holder (3).
2.
Remove screws (4) and take off with wash-
ers (5) and plates (6).
3.
Store the removed parts of the transport
locking device carefully together with this
documentation for possible reuse.
MS15058/04E 2018-12
| Transport | 23
TIM-ID: 0000004010 - 016
Summary of Contents for 20V4000G44F
Page 4: ......
