Centrifugal oil filter – Cleaning and
filter-sleeve replacement
1.
Remove clamp (3).
2.
Release cover screw (1) and take off cover
(2).
3.
Carefully lift rotor (6), allow oil to drain and
remove from housing.
4.
Holding the rotor (6) firmly, release rotor
cover nut (7).
5.
Take off rotor cover (8).
6.
Remove filter sleeve (10).
7.
Measure thickness of oil residues on filter
sleeve (10).
8.
If maximum layer thickness of oil residues
exceeds 45 mm, shorten maintenance in‐
terval.
9.
Disassemble rotor tube (11), conical
disk (12) and rotor base (14).
10.
Wash rotor cover (8), rotor tube (11), coni‐
cal disk (12) and rotor base (14) with cold
cleaner.
11.
Blow out with compressed air.
12.
Check sealing ring (13), fit new one if nec‐
essary.
13.
Assemble rotor tube (11), conical disk (12)
and rotor base (14) with sealing ring (13).
14.
Insert new filter sleeve (10) in rotor tube
(11) with the smooth paper surface facing
the wall.
15.
Check sealing ring (9), fit new one if neces‐
sary.
16.
Mount rotor cover (8) with sealing ring (9).
17.
Tighten rotor cover nut (7) with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Nut
Tightening torque
35 Nm to 45 Nm
18.
Place rotor (6) in housing (5) and check for ease of movement.
19.
Check sealing ring (4), fit new one if necessary.
20.
Fit sealing ring (4) on housing (5).
21.
Fit cover (2).
22.
Fit cover screw (1) by hand.
23.
Install clamp (3) and tighten with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Clamp
Tightening torque
8 Nm to 10 Nm
24.
Tighten cover nut (1) with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
Tightening torque
5 Nm to 7 Nm
104 | Task Description | M015675/05E 2011-10
TIM-ID: 0000000934 - 007
