MT.DERM artyst NR.1, Instructions For Use Manual

Page: 39 / 146

39 EN artyst NO.1
The surfaces of the device are resistant
to:
O
Weak acids (e.g. boric acid ≤ 10%,
acetic acid ≤ 10%, citric acid ≤ 10%)
O
Aliphatic fluorocarbons (e.g. pentane,
hexane)
O
Ethanol
O
Most inorganic salts and their aqueous
solutions (e.g. sodium chloride, cal-
cium chloride, magnesium sulfate)
The surfaces of the device are not resis-
tant to:
O
Strong acids (e.g. hydrochloric acid
≥ 20%, sulfuric acid ≥ 50%, nitric acid
≥ 15%)
O
Oxidizing acids (e.g. peracetic acid)
O
Lyes (e.g. caustic soda, ammonia and
all substances with a pH value > 7)
O
Aromatic/halogenized fluorocarbons
(e.g. phenol, chloroform)
O
Acetone and gasoline
7.3 Disinfecting surfaces
E
Disinfect the control unit, metal plate,
power supply and handpiece cable as
described in chapter 5.5 on page 35.
7.4 Cleaning surfaces
In the event of external contamination:
E
Wipe the device and its accessories
with a soft cloth moistened with a
cleanser or disinfectant.
8 Transport and storage condi-
tions
NOTICE
Device damage caused by dropping it
If the device is dropped, it can be damaged.
E
If the device falls, perform a visual in-
spection of the components.
E
Hand over the device to a specialist re-
tailer for inspection if it exhibits any ex-
ternal signs of damage or if it does not
function normally.
E
Always transport the device and its
accessories in the original packaging.
E
Fasten the metal plate of the device
for transport on the rear side.
E
Always store the device and acces-
sories under the following conditions:
Ambient tem-
perature
-10°C to +40°C
+14°F to +104°F
Relative hu-
midity
10% to 90%
Air pressure 540hPa to 1070hPa
9 Troubleshooting
9.1 Remedying problems when
operating the handpiece
If a longer signal tone sounds when the
handpiece is started and the message
CONNECT HANDPIECE or SYSTEM OVER-
LOAD appears on the display:
E
Ensure that a handpiece is connected
to the device (see chapter 5.4 on
page 35).
E
Ensure that you only use artyst hand-
pieces. Otherwise, the device can be
overloaded.