MT.DERM artyst NR.1, Instructions For Use Manual

Page: 35 / 146

35 EN artyst NO.1
voltage must correspond to the device
voltage designated on the label of the
power supply.
E
If a suitable country-specific adapter is
not included in the scope of delivery of
the device, contact your local special-
ist retailer (also see chapter 9 on
page 39).
To remove a previous country-specific
adapter, if necessary:
E
Pull and hold the holder for the
adapter back, while simultaneously
lifting the country-specific adapter out
of the recess of the power supply.
To insert the desired country-specific
adapter:
E
Insert the country-specific adapter in
the recess of the power supply as
shown below.
E
Press the adapter onto the holder until
it audibly engages.
In order to establish the power supply:
E
Plug the DC plug of the power supply
into the jack for the power supply (
)
E
Plug the power supply into the power
outlet.
The device starts and the display
shows the logo “artyst” for 3 seconds.
The switch to standby mode is indi-
cated by rectangles running from left
to right.
5.3 Connecting the foot switch
(optional)
Only the foot switch cited in sec-
tion 4.3 on page 32 will ensure safe op-
eration.
E
Plug the cinch plug of the foot switch
into the jack for the foot switch (
).
5.4 Connecting the handpiece
E
Insert the plug of the handpiece cable
completely into the output socket on
the control unit.
5.5 Cleaning and disinfecting the
equipment
NOTICE
Damage caused by fluid
If cleansers or disinfectants get inside the
handpiece, the control unit or the power
supply, a short-circuit can occur. The elec-
trical and mechanical components can
also corrode.
E
Never immerse the handpiece, control
unit or power supply in cleansers or
disinfectants.
E
Never clean the handpiece, control unit
or power supply in autoclaves or ultra-
sonic baths.
E
Pay attention to compatibility of materi-
als when selecting cleansers and disin-
fectants (see chapter 7.2 on page 38).