71
Telemetry Module
GB
G1 Integrated SCBA System
Tagging In During Use
WARNING!
When using an ID Tag with the G1 power module, the ID Tag must touching the power module
during this process. If the tag is not, the device can lockup. To fix the lockup, the batteries must
be removed for 30 seconds and then reinstalled.
Misuse can result in serious injury or death.
15.2 Using the Base Station with the Telemetry Module
The telemetry module is designed to work in conjunction with a remote base station unit. This base
station unit must be connected to a personal computer or notebook computer before use. Refer
to the MSA alphaCONTROL 2 Software Instructions for more information.
WARNING!
Follow the PC or notebook computer manufacturer's recommendations regarding exposure to
environmental conditions to prevent damage to the computer.
Failure to obey this warning can cause computer failure and the loss of monitoring capability on
the PC or notebook computer.
(1) Take the ID tag and place in hand.
(2) Place the tag in front of the RFID reader located on the
power module.
The RFID reader is located on the user's right hand side
of the backplate
(3) Press and hold BOTH green RESET buttons at the
same time until the RFID symbol appears.
(4) Keep the tag located at the power module until the blue
bar moves across the screen.
a) If the tag was successful, the information will be
displayed on the tag. If it is not, repeat the steps
above until the tag information is displayed on the
screen.
