MS ENERGY ATOM a1, Instruction Manuals

Page: 106 / 124

ENG
27
Maximum height of the seat: move the quick release handle to the
OPEN
position, then lift the Seat post to the top but the safety line is not exposed,
when it is the maximum height of the seat. Measurement method: place the
bike perpendicular to the ground, and the distance from the highest part of the
curved surface of the seat vertical to the ground is the height of the saddle.
Braking system
The braking system is an accessory necessary for each bike and is the key to
traffic safety; before driving, you must understand your braking system, and do
a good job in the inspection and adjustment work.
The general idea is that upon hard braking, the bike will surely stop in a short
distance, but that is wrong. Upon hard braking, when the wheels are suddenly
jammed by the brake rubber, the bike will glide horizontally, and it not only is
dangerous but the braking distance will be lengthened. Therefore, the concept
should be established is that the braking system is only used to adjust the speed
of the bike.
The braking system typically includes a Brake handle, brake (disk brake or V
brake) and brake cable.
Brake handle
The structure of the Brake handle
is as shown (in the right drawing),
and the left Brake handle controls
the front brake and the right Brake
handle controls the rear brake.
The adjusting screw is used to
adjust the distance between the
brake shoe block and the Rim.
Note : The effective stroke of the brake cable is about a half of the distance
between the handle of the Brake handle and the grip of the Across handle
Stems; if the brake is tight when the handle of the Brake handle is almost
approaching to the grip of the Across handle Stems, the distance between the
brake shoe block and the Rim is too large, it needs to be adjusted.