MRV Communications LambdaDriver 400, User Manual

Page: 135 / 207

LambdaDriver 400 & 800
ML46430, Rev. 07
October 2004
Chapter 4
Startup, Setup, and Operation
Startup
To start up the LDx00, set the switch of each Power Supply to the I (On) position. This
causes the LDx00 to undergo initialization.
Setup
Default Settings
The LDx00 is set up at the factory before it is shipped out. This setup is referred to as the Default
Setup. The default settings can be
changed to suit the administrator as described in the section
Custom Settings . The administrator can also restore all the default settings with the single CLI
command
init-nvram
.
The Default Settings (and the CLI commands for changing them) are given in Table 17 .
Table 17: Default Settings
Console
Setting No.
Description Value
CLI Command
1 Page Size – Number of lines per console page. 22 set-page
2 Prompt – Prompt given by console. SYS_console> set-prompt
3 Password – password required for accessing
console.
Enter
set-password
System
Setting No.
Description Value
CLI Command
1 Baud Rate – Rate in baud at which the LDx00 can
communicate on the serial channel via the RS-232
port.
9600
(fixed)
(None)
2
TFTP File Name – Name of SNMP Agent software
file to be downloaded.
flash.hex set-sw-file
3 TFTP Server IP Address – IP address of TFTP
server (relevant only if the TFTP Mode is Client ).
0.0.0.0 set-tftp-srvr
4 TFTP Mode – Whether the LDx00 is a Client or
Server for the SNMP Agent software file.
client set-tftp-mode
IP
Setting No.
Description Value
CLI Command
1 IP Address – IP address of device agent. 0.0.0.0 set-ip
2 Default Gateway – IP address "default gateway"
node where packets should be sent in the absence of
other routing information.
0.0.0.0 set-gatew
SNMP
135