MRV Communications LambdaDriver 400, User Manual

Page: 111 / 207

LambdaDriver 400 & 800
ML46430, Rev. 07
October 2004
Figure 41: DIP Switch Location on TM-DXFP Transponder Module
ESCON Module
For each pair of ESCON modules to be linked to each other, do as follows:
For one ESCON module:
With the aid of Figure 42, locate the MASTER pins ( J2 ) and make sure they are connected with a
2-pin jumper. (The SLAVE pins ( J3 ) must be left unconnected.)
In Table 16, identify the DIP switch setting for which the operating wavelength is equal to that of
the SFP. With the aid of Figure 42, locate the DIP switch, and set it accordingly.
For the other ESCON module:
With the aid of Figure 42, locate the SLAVE pins ( J3 ) and make sure they are connected with a
2-pin jumper. (The MASTER pins ( J2 ) must be left unconnected.)
In Table 16, identify the DIP switch setting for which the operating wavelength is equal to that of
the SFP. With the aid of Figure 42, locate the DIP switch, and set it accordingly.
Note
Make sure the DIP switches have the same setting in both ESCON
modules to be linked to each other.
111