2
i. Place
&/50
310 colorimeter according to Figure 2. The measuring port of
&/50
310 is
butted up against that of square integrator, as shown in Figure 3. Then, use
⑥
push plate
to hold
&/50
310 colorimeter and tighten
⑦
the screw. Check whether
&/50
310 colorimeter
is loose or not. If it is loose, please re-tighten the screw.
ii. Put the
④
Cuvette into the
③
Square Integrator. There are two matte surfaces in the
cuvette. Please only touch these two matte surfaces when hold the cuvette. In addition,
there are two transparent surfaces which engraved with “MAX” and “MIN”. Please put
one surface against the measuring port of the square integrator, as shown in Figure 3.
iii. Put
④
the Cuvette into
③
the Square Integrator. Cover the
⑤
cover plate. There is
an arrow icon in the cover plate. Meanwhile, square integrator also has an arrow icon.
Please make sure the location of these two arrows is consistent.
After finishing the above steps, you can start the measurement.
