IEF-G9010 Series User Manual
25
Switching to Bridge Mode
Steps:
1.
Go to [Network] > [Operation Mode].
The [Operation Mode] tab will appear.
2.
Click the [Bridge Mode] radio button.
The [Network Settings] section for Bridge Mode will appear.
3.
In the [Network Settings] section, configure the following network settings:
a.
IP Address
: Enter a valid IP address.
b.
Subnet Mask
: Enter the subnet mask.
c.
Gateway Address
: Enter the gateway address.
d.
(Optional)
DNS
: Enter a DNS address.
e.
(Optional)
VLAN ID
: Use the toggle to enable or disable VLAN ID. If enabled, enter the VLAN ID.
f.
(Optional)
STP
: Use the toggle to enable or disable STP (Spanning Tree Protocol).
4.
When finished, click
Save
.
NOTE
When switching from Gateway to Bridge Mode, the Port Mapping, Network Interface, NAT Rules, ALG, and
Static Route functions will be unavailable and cannot be configured.
NOTE
Policy enforcement rule configurations are not compatible between Gateway and Bridge Mode. Therefore,
policy enforcement rules must be reconfigured after switching operation modes.
