Motorola WT4090, Integrator Manual

Page: 148 / 206

7 - 10 WT4070/90 Wearable Terminal Integrator Guide
Figure 7-7
Configure Build Window
2.
Select the items (partitions) to build using the check box(es) to the left of each named partition.
3.
The
Build Path
defines where to store all built partitions.
4.
Select (hex image) COMPRESSION to reduce the size and speed up the download.
5.
Click
OK
and follow the on-screen instructions.
If one of the partitions being built is the ESSID, a prompt appears requesting the ESSID value. Deselect the
HR (High Rate) check box when building ESSID images for a device with an FH radio.
Figure 7-8
Build ESSID Partition Window
If one of the partitions being built is the Splash Screen, a prompt appears requesting both the source Bitmap
file and the destination HEX file.
6.
A check is performed and if there are no errors, the partition hex files are created.
If the build fails, the hex files are not be created and TCM displays an error message. Two of the most common
reasons for a build failure are:
•
Files defined in the script can not be found. This error can occur when the files referenced by the script are
no longer stored on the development computer or the folders where they are stored were renamed.
•
The total amount of flash memory space required by the script exceeds the image size. To correct this,
reduce the number of files in the partition or increase the size of the partition. See
Defining Script Properties
on page 7-7 for more information about setting the image size appropriately.