Motorola MVME162, User Manual

Page: 37 / 106

Installation Instructions
MVME162/D2 2-11
2
8. Connect the P2 Adapter Board or LCP2 Adapter Board and cable(s) to
MVME162 backplane connector P2. This provides a connection point for
terminals or other peripherals at the EIA-232-D serial ports, SCSI ports,
and LAN Ethernet port.
For information on installing the P2 or LCP2 Adapter Board and the
MVME712 series transition module(s), refer to the manuals listed in
Related Documentation in Chapter 1 (the MVME162 Embedded Controller
Programmer’s Reference Guide provides some connection diagrams).
N
ote
If you intend to use the MVME162 with Port B in an EIA-530
configuration, do not install the P2 or LCP2 Adapter Board
and the MVME712 series transition module. They are in-
compatible with the EIA-530 interface (refer to MVME162
Serial Port 2 in Chapter 4, Functional Description).
9. Connect the appropriate cable(s) to the panel connectors for the EIA-232-
D serial ports, SCSI port, and LAN Ethernet port.
– Note that some cables are not provided with the MVME712 series
module and must be made or purchased by the user. (Motorola
recommends shielded cable for all peripheral connections to minimize
radiation.)
10. Connect the peripheral(s) to the cable(s). Appendix A supplies detailed
information on the EIA-232-D signals supported. Appendix B describes
the Ethernet LAN (Local Area Network) port connections. Appendix C
describes the SCSI (Small Computer System Interface) I/O bus connections.
11. Install any other required VMEmodules in the system.
12. Replace the chassis cover.
13. Connect the power cable to the AC power source and turn the equipment
power ON.