Motorola Confidential Proprietary
Manual Test Procedures
Level 3 Service Manual
3 - 7
Preliminary
Signal On
Setup
UE Signal
Sync.
RF
Network
2
1
BS Signal
Connection
Default All Settings
Analyzer Settings
RF Channel Uplink
Band [|]
Frequency Offset
RX/TX Separation
Measurement Settings
Default Settings
UL Scrambling Code
Analysis Mode
Sync. Mode
Measurement Slot Number
Correlatoin Mode
Threshold
UE Power Control
Default Settings
9750
1922.4
MHz
2112.4
MHz
+ 0.000
kHz
190.000
MHz
0
With Origin Offset
All Slots
0
DPCCH
- 25
dB
Channel
Frequency
Downlink
Analyzer Settings/RF Channel Uplink
WCDMA
Connection Control
FDD
Analyzer/Generator
RF
AUDIO
Analyzer/Generator
Analyzer/Generator
GSM 850
P/t Normal GMSK
GSM 850
Overview
P/t Normal GMSK
Analyzer/Generator
GSM 850
P/t Normal GMSK
GSM 850
Overview
P/t Normal GMSK
HotKeys
Set 1
HotKeys
Set 2
HotKeys
Set 3
HotKeys
Assign.
Menu
Select
Basic Functions
GSM Mobile Station
GSM 850
GSM 900
GSM 1800
GSM 1900
3G UMTS User Equipment
WCDMA FDD
Non-Signalling
Signalling
Selection
GSM Mobile Station(GSM 1800/Signalling/Overview/P/t Normal GMSK
Power
Spectrum
Hotkeys - Set 1
Menu Select
Ch. 2
Connect
Control
Ch. 1
WCDMA
FDD
Spectrum
Band
I
WCDMA Call Processing
In order to successfully complete a GSM call process-
ing procedure, a test USIM card needs to be available.
Test USIM cards have default call parameters that al-
low users to perform call processing tests through GSM
base station simulators. This allows service technicians
perform simulations without accessing the customer’s
cellular account.
Hardware Requirements
Refer to , “Hardware requirements,” under, “GSM/
DCS/PCS Call Processing.” Also Refer to Figure 13.
Software Requirements
None.
Call Origination (WCDMA)
Use the following procedures for call processing. The
screen shots are from a Rohde and Schwarz CMU 200
with WCDMA signalling options installed. The proce-
dures can be adopted to any other test box that will be
used to perform call processing.
1.
Install the test USIM in phone.
2.
Connect hardware as illustrated in figure 4.
Note:
Control interface doesn’t need to be con-
nected at this time.
3.
Setup up the test box for WCDMA FDD Sig-
nalling
4.
Set UE Signal, RF Channel Uplink to 9750
Figure 18. Channel Uplink(UE Signal)
Figure 17. WCDMA Signalling Setup
WCDMA Call Processing
