Motorola Confidential Proprietary
Manual Test Procedures
Level 3 Service Manual
3 - 11
Preliminary
Parameter
Low
Limit
High
Limit
Unit
WCDMA Power Out
20.5
21.5
dBm
Non-signalling Test Procedures
(WCDMA)
To perform non-signalling test procedures, the user is
required to be familiarized with sending test commands
to the phone under test. The test commands can be
sent using the Handset test command interface or
through a computer. Please refer to section,”Handset
Test commands,” for details on how to send test com-
mands through phone keypad entry. Also, refer to,
“Computer Test Commands,” for details on how to send
test commands through the computer.
In order to successfully send test commands to the phone
under test, the phone needs to be in suspend mode.
Follow the listed procedure to place the phone in sus-
pend mode.
Handset Test Commands
54 ok
Suspend
Radio Comm Test Commands
Click AT+MODE then SUSPEND
(Serial Only)
Click PST Initialize and click SUS-
PEND when initialization is complete
(USB Only)
Hardware Requirements
Refer to page 2 for a list of Hardware. Refer to Figure
4 for a configuration illustration.
Table 9. WCDMA TX Power Output
Software Requirements
Handset Test Command
•
No software needed
Computer Test Command
•
Radio Comm (latest release)
Verify TX Power Output (WCDMA)
Verify the TX Power output by initiating the commands
in this section. Verify that the results fall within the fol-
lowing limits.
Handset Test Commands
54
Suspend
3086
W_CARRIER
Field 1
9750
Set Channel
Field 2
0
Enable Carrier
Field 3
023
Max Power Out
Field 4
027
Max TX Power
Field 5
206
Min TX power
Field 6
002
PN9 Data pattern
Field 7
1
Enable spreading
Field 8
01
Long scrambling
Field 9
000
SF256, Slot format 0
Field 10
000
SF256, Slot format 0
Field 11
000
Channelization Code
Field 12
000000000
Scrambling Code
Note:
Enter 1 in field 2 to disable carrier
Non-signalling Test Procedures (WCDMA)