locking system. The latching system used is the double action catching to
ensure secure and safe latching.
There are some adjustments which can be made to help maintain the entry
door performance. The top portion of the screen door can be removed and
secured to the lower portion for better visibility.
CAUTION: When operating the entry door ensure the dead
bolt latch is fully in the unlock position prior to closing the
entry door. Failure to do so can result in damage to the dead
bolt and/or entry door.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
• Determine which bolt needs adjustment.
• Using a 5/8 inch box wrench or socket, to loosen the movable bolt.
Make all adjustments in small increments. Tighten the bolt firmly
after making adjustments. The bolts should have slight up and down
movement for vibration control in travel.
• Slowly, close the entry door while observing the latch and bolt
alignment. Do not attempt to latch if the alignment is off. If the
alignment is correct, allow the latch to catch in the first position only.
• With just slight pressure applied to the entry door, the latch should
move to the second position. Press on the entry door to see if there is
any further movement of the door.
• The entry handle should operate with little effort to open the entry
door. An excessive amount of pressure indicates the bolts are set too
far back.
• Test the operation of the dead bolt lock to ensure proper functions.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
• Since the glass slider is plexi-glass, the slider can be bowed for
removal and replacement.
• Replace with new plexi-glass and reverse the procedure.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
• Loosen the chrome bolts on the hinge side of the screen door: Four on
the top and four on the bottom.
• There are slots in the steel hinge to allow up and down movement.
• There are four Allen type screws on the top hinge and four on the
bottom hinge to adjust the screen door so it properly fits the entry
door. The hinge should fit tightly to the trim of the door when the
screen door is latched to the door and the door is open.
• Check to see that the pad on the inside of the door is not sitting on top
of the aluminum trim of the door. If it is, it will hold the screen door
away from the door and you will not have a proper seal. If the pad is
too large, re-size the pad.
Operating & Safety
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
E X E C U T I V E
2 • 3 6
ENTRY DOOR -
Latch Adjustments
Screen Door -
Changing the Glass
Screen Door -
Adjusting
Summary of Contents for Executive 2001
