Electrical Systems
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Wiper Wash:
The operation of this switch activates the wash pump relay when the switch is
pressed. In addition, if none of the latching wiper functions (Wiper LO/HI or
Variable) had been previously selected, the Low Speed Wiper will be activated
for a period of approximately three wiper cycles after the switch is released. If
any of the latching wiper functions (Wiper LO/HI or Variable) had been previ-
ously selected, the wipers will continue to run in the selected mode after the
wash switch is released.
Wiper LO/HI:
The operation of this switch initially causes the Low Speed Wiper functions to
activate. If the switch is pressed again the High-Speed Wiper will be activated.
Subsequent presses of this switch will cause alternate operation of the wipers in
the low or high-speed mode.
Wiper Variable:
The operation of this switch initially causes the Low Speed Wiper function to
activate for one wipe. If the switch is pressed again within approximately 30
seconds, the Low Speed Wiper function will be activated again and will repeat
at an interval determined by the time between the last two operations of the
switch. Additional switch operations will shorten the cycle. Activation of any
wiper mode cancels the variable mode. The effect for the driver is thus: In light
rain or mist conditions the driver presses the switch once when windshield first
needs clearing. When the windshield again requires clearing, the driver presses
button again-setting the time period between subsequent wipes to that required
by the current conditions.
Wiper OFF:
The operation of this switch causes all operation of wipers to be canceled.
Turning off the ignition also resets this mode. Pull headlight switch to ON then
back to off to cancel automatic headlight operation.
NOTE: Headlights will come on when any wiper mode is selected.
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Tilt and telescope steering wheel control lever is located on the steering
column.
• To tilt the steering wheel, pull the lever up. Tilt the steering wheel where
you want it. Release the lever and it will lock the steering wheel in the new
position.
• To telescope the steering wheel, push and hold the lever down. Push down
or pull up on the steering wheel until the wheel is where you want it.
Release the lever and the steering wheel will lock in the new position.
5 • 1 7 5
EXECUTIVE
Wiper Functions
Tilt & Telescope
Smart Wheel Wiper Controls.
Summary of Contents for Executive 2001
