
76
Appendix E.
mogwave
configuration
-h
help
-c
configuration filename
-d
debug options
-ip
IP
address
-l
enable logging of errors
-m
maximum exposure time (ms)
-p
TCP/IP
port or
USBCOM
channel
-r
sensor row
-s
simulation wavelength
-t
timeout multiplier
-u
USB
enable
-f
FZW for calibration (y/n)
-w
HighFinesse for calibration (y/n)
-c The configuration filename; see below.
mogwave
will first try to open
the file within the current working directory (the directory where
mogwave
is located, or the “
Start in
” directory specified in the
shortcut link). If not found, it will search for the file in the default
configs directory within the
mogwave
directory.
-d Debugging flags. Integer value; set odd to save etailed measure-
ments when recording data.
-m The maximum exposure time is by default 100 ms. Longer times can
make the software unresponsive but may be useful for measuring
very low-power lasers or pulsed lasers with low pulse rate.
-r The sensor row specifies the pixel row on the sensor to use for data
acquisition. The default is set in the factory but adjustments may be
neede when changing fibres or after mechanical disturbance.
-s Floating point wavelength in nm.
mogwave
can simulate measure-
ment if no laser light is available. Value must be within wavelength
measurement range.
Summary of Contents for MWM
