
56
Appendix B. Communications
Look again for the virtual COM port within
Device Manager
. If you see
STMicroelectronics COM Port (COMxx)
and the device is not connecting
then you need to tell the software (
mogwave
) which port to use. This is
most easily done by editing the default configuration file,
C:\Program Files (x86)\MOGLabs\mogwave\configs\default.cfg
.
Change the two lines
# usb_port = COM15
# usb = False
to
usb_port = COMxx
usb = True
where
xx
is the COM port shown in Device Manager.
You can also specify
USB
and the port via command-line options for
mogwave
.
Edit the shortcut link to add
-u
to force
USB
, and
-p xx
to specify the
port number.
1. Right-click on the
mogwave
desktop shortcut and select
Properties
.
2. Edit the
Target
to add
-u -p xx
at the end (see figure below). It
should be something like
C:\Program Files (x86)\MOGLabs\mogwave\mogwave\mogwave.exe -u -p 15
.
3. Select
Apply
to save the new shortcut.
Summary of Contents for MWM
