
D.7 Configuration settings
71
mac
set,mac,"xx.xx.xx.xx.xx.xx"
Set ethernet
MAC
address. The device is factory configured with a
MAC
address reserved by
MOGL
abs from the IEEE REgistration Authority. It
should not be necessary to change the default MAC address.
ipport
set,ipport,u16
Set the
TCP/IP
port number to unsigned 16-bit
u16
. The device will respond
to
telnet
queries on that port. Note that if the command is being sent
via
TCP/IP
, and the port number changes, the communications link will be
closed.
dhcp
set,dhcp,u16
Enable or disable
DHCP
. Zero or
−
1 (0xffff ) disables; any other value
enables.
pcorrect
set,pcorr,int
Correction value for pressure, signed 16-bit
int
.
camvars
set,camvars,rowstart,colstart,nrows,ncols,swu,swl,binx,biny,gain
Set imaging sensor field of view, shutter time, binning and gain.
avgcnt
set,avgcnt,u16
Number of measurements to average when calculating and displaying
wavelength on the device.
row
set,row,u16
Defines row of imaging sensor used for acquiring interference pattern,
calculating spectrum and wavelength.
0
≤
u16
≤
1943, should be even.
maxshutter
set,max,u16
Maximum exposure shutter time in milliseconds, unsigned 16-bit integer.
Default is 100. Note that the device will self-reset if suspended for more
than about 16 seconds, imposing a hard limit on the exposure time.
qcal
set,qcal,double0,double1,double2,double3
Calibration coefficients used by mogwave. Each coefficient is a double-
precision real number.
Summary of Contents for MWM
