MJ Research PTC-0200, Operation Manual

Page: 84 / 143

8-8 8-8 8-8 8-8 8-8
DNA Engine & DNA Engine Tetrad Operations Manual
The cursor will be positioned at the port currently in use.
To choose the serial port, select Serial, then press « Proceed ». The cursor
will move to Serial, and a line allowing a baud rate to be specified will be
displayed on the last line of the screen:
Select a baud rate, then press « Proceed ». The remote port assignment
will change to serial, and the Main Menu will be displayed.
To choose the IEEE-488 port, select IEEE-488, then press « Proceed ».
The cursor will move to IEEE-488, and a line allowing the DNA En-
gine to be assigned an IEEE-488 address will be displayed on the last
line of the screen:
The machine’s current address will be displayed. To change it, enter a
number from 0–30, then press «
Proceed ». The remote port assign-
ment will change to IEEE-488, the address number will be assigned
to the machine, and the Main Menu will be displayed.
Note Note
Note Note
Note : Do not choose 0 for the machine address unless the DNA Engine
will be a controller in a network (see chapter 9).
Choosing a Printer Port
To choose a printer port, select Printer from the Setup Menu, then press
« Proceed ». The port selection screen will be displayed:
Select the desired port, then press « Proceed ». If serial was chosen, specify
the printer’s baud rate as for “Choosing a Remote Port” (p. 8-7).
Printer:
Parallel _SERIAL
Printer:
_SERIAL IEEE-488
Baud: 9600 2400_1200
Printer:
Serial _IEEE-488
Address (0-30): 0