MITSUBISHI ELECTRONICS AMERICA, INC.
ST200 Series Technical Support Manual
53
January 2000
Standard Horizontal CTU Installation Steps
Required tools
: Phillips (No. 2) screwdriver and drill (3.6mm).
Use standard or specified hardware and install securely. Do not damage the fuel tank or vehicle
cables when drilling the holes through the trunk floor.
a)
Install “Angle Bracket-A” to both sides of the CTU. Find a level and stable area in
the trunk. Mark the trunk floor at the position of the four oval holes on the lower side
of “Angle Bracket-A”. Make sure that the installed CTU does not interfere or make it
difficult to take out or put back the spare tire or tools.
b)
Use the drill to make holes 3.6mm in diameter at the marked positions on the floor.
Carefully check the vehicle to make sure that you do not damage systems or items
under the floor (e.g., gas tank, exhaust pipe, catalytic converter, vehicle wiring, etc.)
c)
Secure the BSU. Connect the interface cable to the CTU, and use standard screws
(M5x20 self-tapping screws) to secure the CTU. Secure the interface cable so that it
can not be damaged when loading/unloading the trunk (securing materials are not
included).
