MITSUBISHI ELECTRONICS AMERICA, INC.
ST200 Series Technical Support Manual
106
January 2000
9.
Click “OK” again to return to Modems Properties. Click “Close” and then close Control
Panel.
4. Configure the CTU for data service
Enter FCN 92 to configure port settings on the phone. Set to: Data bits =
8
, Parity =
N
, Stop bits
=
1
, and speed =
4800
bps. When properly configured, the handset will display:
48 8N1
.
5. Start the data communications session
1.
Start the communications software package.
2.
Within the communications software package, select the Standard 9600 bps Modem as the
modem to be used for data communications.
3.
Check that the computer and transceiver are communicating properly by typing “AT” and
<Enter>. You should receive “OK” back from the transceiver.
4.
Establish a data call by sending an AT command to the transceiver: “ATDxxxxxxx<CR>”.
The xxxxxxxx is the phone number of the device you wish to connect to. The handset should
display “SAT DATA CONNECT.”
For further information on using MSAT Circuit Switched Data service, please see your satellite
phone user’s guide or supplemental literature.
