Mitsubishi Electric CITY MULTI CMB-WP1016V-GA1, Service Handbook

Page: 140 / 294

[
VIII
Troubleshooting ]
- 131 -
HWE1410A GB
6603
1. Error Code
Transmission line bus busy error
2. Error definition and error detection method
 Generated error when the command cannot be transmitted for 4-10 minutes in a row due to bus-busy
 Generated error when the command cannot be transmitted to the transmission line for 4-10 minutes in a row due to noise
The address/attribute appeared on the display on the remote controller indicates the controller where an error oc-
curred.
3. Cause, check method and remedy
6606
1. Error Code
Communication error between device and transmission processors
2. Error definition and error detection method
Communication error between the main microcomputer on the indoor unit board and the microcomputer for transmission
The address/attribute appeared on the display on the remote controller indicates the controller where an error oc-
curred.
3. Cause, check method and remedy
6603
Cause Check method and remedy
(1) The transmission processor cannot be transmit-
ted as the short-wavelength voltage like noise ex-
ists consecutively on the transmission line.
Check the transmission wave shape and noise on the
transmission line.
See the section "Investigation of Transmission Wave
Shape/Noise."
-> No noise indicates that the error source controller is a
failure.
-> If noise exists, investigate the noise.
(2) Error source controller failure
6606
Cause Check method and remedy
(1) Data is not properly transmitted due to accidental
erroneous operation of the controller of the error
source.
Turn off the power source of the outdoor and the indoor
units.(When the power source is turned off separately, the
microcomputer will not be reset, and the error will not be
corrected.)
-> If the same error occurs, the error source controller is
a failure.
(2) Error source controller failure
0000002394.book 131 ページ ２０１６年１月１２日 火曜日 午後４時４９分