MIROxi
User Manual cod. 980265
Rev 1.6
Page 31 of 32
ANNEX 2
INFORMATION FOR CORRECT USE IN AN ELECTROMAGNETIC ENVIRONMENT
Guidance and manufacturer’s declaration – electromagnetic emissions
The
MIROxi
is intended for use in the electromagnetic environment specified below.
The customer or the user of the MIROxi should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment
–
guidance
RF emissions
CISPR 11
Group 1
The
MIROxi
uses RF energy only for its internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
Harmonic emissions
IEC 61000-3-2
Not applicable
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Not applicable
Guidance and manufacturer’s declaration – electromagnetic immunity
The
MIROxi
is intended for use in the electromagnetic environment specified below. The customer
or the user of the
MIROxi
should assure that it is used in such an environment.
Immunity test
IEC 60601
test level
Compliance level
Electromagnetic environment
–
guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
±
6 kV contact
±
8 kV air
±
6 kV contact
±
8 kV air
Floors should be wood, concrete or ceramic tile. If floors are covered with synthetic
material, the relative humidity should be at least 30 %.
Electrical fast
transient/burst
IEC 61000-4-4
±1 kV for input/output
lines
Mains power quality should be that of a typical commercial or hospital environment.
Surge
IEC 61000-4-5
±
1
kV
differential
mode
±
2 kV common mode
Not Applicable
Mains power quality should be that of a typical commercial or hospital environment.
Voltage
dips,
short
interruptions and
voltage
variations
on power supply
input lines
IEC 61000-4-11
<5 %
U
T
(>95 % dip in
U
T)
for 0,5 cycle
40 %
U
T
(60 % dip in
U
T)
for 5 cycles
70 %
U
T
(30 % dip in
U
T)
for 25 cycles
<5 %
U
T
(>95 % dip in
U
T)
for 5 sec
Not Applicable
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3 A/m
3 A/m
Power frequency magnetic fields should be at levels characteristic of a typical
location in a typical commercial or hospital environment.
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2,5 GHz
[
3
] V
[
3
] V/m
Portable and mobile RF communications equipment should be used no closer to
any part of the
MIROxi
, including cables, than the recommended separation
distance calculated from the equation applicable to the frequency of the transmitter.
Recommended separation distance
d=
[
3.5 ] P
3
d=
[
3.5 ] P
80 MHz to 800 GHz
3
d=
[
7 ] P
800 MHz to 2,5 GHz
3
where
P
is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer and
d
is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters, as determined by an electromagnetic site
survey, should be less than the compliance level in each frequency range.
Interference may occur in the vicinity of equipment marked with the following
symbol:
