32 | minnkotamotors.com
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION DU RIPTIDE ULTERRA
6
i. Assurez-vous que la fente sous l’extrusion de
base est alignée à la partie extérieure du plat-
bord du bateau. Cela assurera que l’arbre a un
dégagement minimum de 1 1/2 po (3,8 cm)
lorsqu’il est déployé. L’appareil inférieur, lorsqu’il
est arrimé et déployé, ne doit pas rencontrer
d’obstacles.
j. Assurez-vous que le support est de niveau. Au
besoin, utilisez les rondelles de caoutchouc
(article nº 7) pour créer une surface au niveau.
7
k. Il est recommandé de marquer au moins 4 des 6
trous dans l’extrusion de base et d’avoir au moins
deux boulons de chaque côté qui sont le plus
éloignés l’un de l’autre. Une installation idéale
serait d’utiliser 6 boulons avec un minimum de 4.
l. Assurez-vous que la zone sous l’emplacement
pour percer des trous et installer des rondelles
et des écrous est dégagée. Percez les trous aux
endroits marqués à l’aide d’une
mèche de 9/32 po
(7,14 mm)
.
ARTICLE(S) REQUIS
#7 x 6
AVERTISSEMENT
Ne déployez pas le moteur tant que l’installation n’est pas
terminée sur le bateau. Les illustrations sont à titre de
référence seulement. Le déploiement de votre moteur avant
l’installation au bateau pourrait entraîner des blessures.
Plat-bord
Plat-bord
Fente
Fente
Extrusion de Base
Arbre
Plat-bord
1 1/2 po
(3,8 cm)
minimum
Étrave
Trous de Montage
Trous de Montage
Extrusion de Base
Summary of Contents for RIPTIDE ULTERRA 112
