minnkotamotors.com | 29
©2016 Johnson Outdoors Marine Electronics, Inc.
TRIM/STOW RESET PROCEDURE
In the unlikely event Riptide Ulterra will not trim or stow, the following procedure will reset the motor and restore functionality.
If Riptide Ulterra does not reset, repeat the procedure. If the second attempt fails, please contact your local authorized service
center or call Minn Kota service at (800) 227-6433.
Trim/Stow Reset Procedure
1
2
a. Locate the Indicator Panel at the base of
the Mount.
b. Press and hold the Power Button located on the
Indicator Panel to turn the motor off. Make sure
that the motor is off by checking that the green
LED light next to the System Ready Indicator
is off.
c. Press the Power Button until the green LED
illuminates and the motor is turned on.
d. Wait 3 seconds.
e. Press the Power Button 3 times consecutively
within a 2 second period.
f. The red and green LEDs will flash continuously
and the Riptide Ulterra will go through the
following automated sequence:
• The motor will position itself into the
proper orientation.
• The motor will automatically trim up to the
Mount and then trim down approximately
6 inches.
• The flashing red LED next to the System Ready
Indicator will turn off, and the flashing green
LED next to the Status Indicator will become
solid green.
NOTE:
If the Lower Unit of the motor is trimmed
within 6 inches of the Mount and the boat Hull is
obstructing the motor’s turning radius, manually turn
the Control Head of the motor so that the Lower Unit
is perpendicular to the Motor Ramps prior to beginning
this procedure.
WARNING
During this procedure the motor will go into an
automated sequence. Keep fingers clear of all
hinges, pivot points and all moving parts. Ensure
that the motor, or parts of the motor do not contact
the boat, trailer, persons, or any other obstruction.
Status Indicator
Status Indicator
Power Button
Power Button
System Ready
Indicator
System Ready
Indicator
Summary of Contents for RIPTIDE ULTERRA 112
