![background image](http://html1.mh-extra.com/html/minn-kota/riptide-ulterra-112/riptide-ulterra-112_owners-manual_1802797060.webp)
8 | minnkotamotors.com
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RIPTIDE ULTERRA
6
i. Make sure the slot on the underside of the Base
Extrusion is aligned with the outermost part of
the gunwale of the boat. This will ensure that the
Shaft has a minimum clearance of 1-1/2" when
it is deployed. The lower unit when stowed and
deployed must not encounter any obstructions.
j. Check to be sure that the Mount is level. Use the
Rubber Washers (Item #7) provided to create a
level surface if necessary.
7
Bow
k. It is recommended to mark at least 4 of the 6
holes in the Base Extrusion to have a minimum
of two bolts on each side that are located the
farthest apart. Ideal installation would allow for
6 bolts to be used, with a minimum of 4.
l. Make sure the area under the mounting location
is clear to drill holes and install nuts and washers.
Drill through the marked holes using a
9/32
"
drill bit.
ITEM(S) NEEDED
Mounting Holes
Mounting Slots
Base Extrusion
#7 x 6
Gunwale
Gunwale
Slot
Slot
Base
Extrusion
Shaft
Gunwale
1-1/2"
Minimum
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor
before it is mounted to the boat may cause injury.
Summary of Contents for RIPTIDE ULTERRA 112
