![background image](http://html1.mh-extra.com/html/minn-kota/endura-max-engine-mount-160/endura-max-engine-mount-160_owners-manual_1802769014.webp)
14 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE CONTROL MODULE AND CONNECTING IT TO THE MOTOR
Installing the Control Module and Connecting it to the Motor
a. Make sure that the key is removed from the ignition
and review the Mounting Considerations to determine
an acceptable mounting location.
b. Take the Control Module (Item #D) and double check
the mounting location. Use a Marking Tool to mark
the four Mounting Holes of the Control Module on
the mounting location. Take the Control Module and
set it aside.
c. Take a Drill with a 1/8" Drill Bit and drill four pilot
holes on the marked locations.
d. Replace the Control Module and secure it with the
four Boat Screws (Item #18) into the pilot holes.
1
ITEM(S) NEEDED
WARNING
Remove the ignition key before beginning installation to
prevent accidental starting of Outboard Engine during
installation.
The Control Module contains all of the electronics that are used
to control the speed of your Engine Mount. It is recommended
to mount the Control Module on a flat surface in or near the
battery compartment. Make sure that the motor Lead Wires
coming from the Engine Mount can reach the Lead Wires on the
Control Module. The Lead Wires on the Control Module are on
the opposite end of the Control Module from the Hand Control
Connection Wire. The Hand Control Connection Wire is identified
by a pin plug with a threaded connection.
Control
Module
Hand Control
Connection Wire
Lead
Wires to
Battery
Lead Wires
to Motor
Mounting
Location
Control
Module
Mounting
Holes
Marked
Location
Drill
Screw
Drill
Screw
Mounting
Holes
1b
1c
1d
Mounting
Location
Mounting
Location
Marked
Location
Control
Module
#D x 1
#18 x 4