18
F
rançais
ATTENTION :
•
Ne jamais utiliser le moteur hors de l’eau.
•
Le serrage excessif des vis de serrage risque d’endommager le support.
RÉGLAGES
Réglage de la direction :
•
Régler le bouton de tension de direction pour fournir une tension suffi sante permettant au moteur
de tourner librement, tout en restant dans n’importe quelle position sans avoir à être tenu; ou
•
Serrer le bouton pour mettre le moteur dans une position prédéfi nie afi n d’avoir les mains libres
pour
pêcher.
Réglage du support :
•
Le moteur peut être fi xé à la verticale, incliné en eaux peu profondes ou complètement basculé
hors de l’eau.
•
Saisir fermement la tête de commande ou l’arbre composite.
•
Appuyer en continu sur le levier de basculement.
•
Basculer à n’importe quelle position sur le support.
•
Relâcher le levier de basculement.
INSTALLATION DU MOTEUR
Bouton de réglage de la profondeur
Vis de tension de direction
Levier de basculement à libération rapide
Vis de serrage
AVERTISSEMENT : Lors du hissage/de l’abaissement du moteur ou de l’utilisation du mécanisme
de basculement, tenir les doigts à l’écart de tous les points de pivot et charnières, et de toutes
les pièces en mouvement.
7
PROPELLER REPLACEMENT
English
Disconnect motor from battery prior to changing the propeller.
•
Hold the propeller and loosen the prop nut with a pliers or a wrench.
•
Remove prop nut and washer. If the drive pin is sheared/broken, you will need to hold the shaft
•
steady with a screwdriver blade pressed into the slot on the end of the shaft.
Turn the old prop to horizontal (as illustrated) and pull it straight off. If drive pin falls out, push it back
•
in.
Align new propeller with drive pin.
•
Install prop washer and prop nut.
•
Tighten prop nut 1/4 turn past snug. (25-35 inch lbs.) Be careful, overtightening can damage prop.
•
CAUTION:
Disconnect the motor from the battery before beginning any prop work or maintenance.
MAINTENANCE
This motor is not designed for saltwater use.
1.
Use of this product in saltwater will void your
warranty.
The propeller must be cleaned of weeds and fi shing line. Line can get behind the prop, damage the
2.
seals and allow water to enter the motor. Disconnect battery and check this after every 20 hours of
operation.
To prevent accidental damage during trailering or storage, always disconnect the trolling motor from
3.
battery. For prolonged storage, lightly coat all metal parts with silicone spray.
Prop Nut
Washer
Weedless Propeller
Slot End
Drive Pin