Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 22 / 94

Check the ☑ box to activate the module. The
menu expands.
— IP address Enter the IP address of the module.
— I/O type Selection: Digital input, Digital output
— Input 1…16
— SPM address %MX See SPM table in Chapter 8 .
— Default Settings are reset to factory settings.
— Input/Output - Switch to previous Input/Output.
— Input/ Switch to next Input/Output.
— Save The settings are saved.
— Limit values Deine switch on/switch of points.
— Weighing point Weighing point A…B
— Limit value 1…2 On/of Enter 0…Max (maximum capacity);
Adopt unit from the calibration.
— Default Settings are reset to factory settings.
— Save The settings are saved.
— Parameters Deine the parameters for the applications.
— Printer for conig. print-out No printer, Printer, Printer 1, Printer 2
— Dialog manual phase Conigure the operation dialog.
Default setting: Start dosing
Enter alphanumeric characters (max. 30).
— LOT input ield
Preset the entry using keypad: Text = ,
Numeric = ; max. 18 characters
— ID input ield Preset the entry using keypad: Text = ,
Numeric = ; max. 18 characters
— Default Settings are reset to factory settings.
— Save The settings are saved.
— Production lines Load (refresh) the production lines created and
conigured in P.
— Name of production line (e.g.: PL 1) Check the ☑ box to activate the production line.
— Default Settings are reset to factory settings.
— Load The production lines are displayed in the form
of a list.
— Save The settings are saved.
4.1.4 Limit values
Coniguration
Limit values
4.1.5 Parameters
Coniguration
Parameters
4.1.6 Production lines
Coniguration
Production lines
Phase PR 5900/81 4 Setting up the application menu
EN-20 Minebea Intec