Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 24 / 94

— Save The settings are saved.
— View of weighing point Incorporate the view into the visualization.
— Number of lines Number of lines that is to be displayed.
— Status of weighing point Not active, active
— 1st line Display only: WP status material
— 2nd to 6th line [Status WP] - [active] selected: Possible
selection: Production line, recipename, recipe
line, target value, actual value, diference
(between target value and actual value), gross,
blank line
[Status WP] - [not active] selected: Possible
selection: Gross, blank line
— Default Settings are reset to factory settings.
— Save The settings are saved.
— Simulation Only possible if the dosing license has been
activated and the "Settings locked" parameter
has not been enabled.
— Weighing point A…B Check the ☑ box to activate the corresponding
weighing point for the simulation.
— Material low Only possible if a weighing point has been
selected.
Applies the weight value from the scale (in this
case, g).
Enter value for coarse low, e.g.: 100 g/sec
— Default Settings are reset to factory settings.
— Save The settings are saved.
— Printing
4.1.9 View of weighing point
Coniguration
View of weighing point
4.1.10 Simulation
Coniguration
Simulation
4.1.11 Printing
Coniguration
Print coniguration.
Phase PR 5900/81 4 Setting up the application menu
EN-22 Minebea Intec